← All articles
Sensor Article

Sensor basics: From Physical Quantity to Electrical Signal

The pure fundementals of how sensors work. How does a sensor turn a physical quantity into something measurable?

SensorsStrain gauge

Strip away the packaging and most sensors function in principle the same way. A transducer turns a physical quantity into an electrical signal, often as a voltage difference. This can in turn be fed into an analog to digital (AD) converter to make the signal readable for computers.

Strain gauges

Strain gauges can measure the strain experienced within a material by exploiting the fact that as a material becomes stretched, the area of the cross-section changes. This will in turn change it's resistance to electricity, which causes an higher voltage drop across it.

The change of area of the cross section after an axial load is applied is explained by the Poisson effect. It is modeled using the Poisson's ratio ν\nu:

ν=−εtransεaxial\nu = - {\varepsilon_{\text{trans}} \over \varepsilon_{\text{axial}}}

Where ε\varepsilon is a symbol for the strain, in this case along the transitial and axial direction. Assuming a positive Poisson's ratio, stretching along the axial direction, will shrink the radius of the cross section. This change in area directly contributes to a change in resistance as the resistance is given by:

R=ρLAR = \rho {L \over A}

where R is the resistance, ρ\rho is the resistivity, L the length, and A the area of the cross-section. In accordance to Ohm's law, this change in resistance will change the voltage drop across the rod as long as current is going through it which can be measured. The change in resistance is minuscule, so to increase the sensetivity of the sensor, a wheatstone bridge is constructed so the signal can be amplified. Finally, the signal can be digitlized and sent to a computer for analysis.